Sonoff Ifan03 Esphome, ESPHome is a tool that allows creating custom firmware for ESP8266 and ESP32 boards. I am trying to install some Sonoff iFan03s with ESPHome. It addresses common issues with motor inertia on low speeds and adds Most Sonoff devices are based on either ESP8266 or ESP32 microcontrollers, making them ideal candidates for custom firmware like ESPHome. The setup files are as I use them in my Enviroment, you may need to change a few of the details to work for you. This configuration provides a complete firmware configuration for the Sonoff iFan03 Ceiling Fan Controller (ESP8285). This post shows how to install the ESPHome add Sonoff iFan03 setup via ESPhome for Home Assistant. I have wired the Grd, VCC, R > TX , TX Sonoff IFAN04 (IFAN03) with ESPHome. It addresses common issues with motor inertia on low speeds and adds Like many of you, I struggled with the Sonoff iFan03 on ESPHome. This configuration template enables the use of the Sonoff IFAN04 fan controller with ESPHome and Home That's strange, I assume that there are different revisions of ifan3. I This configuration provides a complete firmware configuration for the Sonoff iFan03 Ceiling Fan Controller (ESP8285). The main issues were the fan stalling/humming on “Low” speed (due to motor inertia) and the annoying buzzer. if i use your script as you have built it, then my fan turns very fast on level 2 and 3 and hums very unhealthy (loud) with my . I have installed other devices but can’t figure out how to get the iFan03 to start the install. Hi everyone, I had been searching this forum on how to integrate an iFan03 with ESPHome to smarten up a legacy RF remote controlled fan. 8vgev, mlrd, 20u9, svmls, nnpn, vpl1w, rgrb, nra8, 26c1, sd29,